Electronics Production

 

The fourth week is talking about how to make an in-circuit programmer

and program our own isp board
The design is ready and all I'm doing is that are required to use the Roland Modela cnc and soldering the into the board components

 

for me the soldring was't the isue at all but the whole isue is using the rolan modela

but the assingment rquire to use theis machine

 

Photos from start to finish

 

 

then I solderd the commpents

after this phase you must burn the frimware on your isp

I'm using mac , so I

 

 

then I conected the isp board with AVR dude

 

 

the I opend the terminal and write the following